Flood detector 1W-UNI 3m: Spot detection

A simple water flood sensor (water level) detects electrically conductive fluid through 4 outlets on the detector body (spot detection). The sensor can be placed on a wall or floor with a dielectric surface.

Using an RJ11 cable, it connects directly to the 1W-UNI port (Poseidon, Ares, STE2, ..) where the sensor shows the values 1 (flooded) / 0 (non-flooded).

Features: 
  • Water flood spot detection
  • The sensor may be submerged below the fluid surface.
  • The middle hole facilitates mounting on a wall.
  • RJ11 sensor for STE2 / Ares / Poseidon2 LAN/GSM monitoring units.
Applications and usage: 
  • Detection: Water flood sensor (spot detection)
  • Interface: 1-Wire UNI (RJ11)
  • Cable length: 3m
  • Connects to: Poseidon2 (LAN monitoring), Ares (GSM monitoring)
     
  • Power supply: Powered from the 1-Wire UNI bus (RJ11)
  • Environment: Indoor or outdoor use

Horizontal menu

Simple spot water sensor. Detects water using four protruding pins on the sensor body. It has to be completely flooded to trigger an alarm.

The attached 3m cable can be directly connected to a RJ11 port of Ares or Poseidon2 monitoring units for water alarm.

The flood sensor can be left lying on the floor (on an electrically insulating surface), or attached to the floor or to a wall. Designed for flood detection, senses water and other electrically conductive liquids.

Monitoring the flood detector over LAN

  • The water flood sensor connects to the RJ11 connector for 1-Wire UNI sensors.
  • Flood detector does not need external power.

GSM water alarm when water is detected

  • All three sensors are connected to the T-Box hub for 5 RJ11 sensors.
  • The sensors are powered from the Ares internal battery even in case of power supply failure.

 

Why is Water Leak Detection system better than Flood detector

Water Leak detection vs. Flood detectionWater Leak Detection with the sensing cable is more expensive than simple spot water detection. However, WLD provides a much faster reaction to any water in the room. Thanks to the early alert significant damages to IT or other infrastructure can be avoided. Water Leak Detection with sensing cable is recommended in IT, data centers, technology, the medical sector, or anywhere else, where any water damage would be highly expensive.

Proper Water Leak Detection with a sensing cable helps you avoid costly damages thanks to an early alert that is triggered by the first few drops of liquid. Learn more about the difference between the WLD system with sensing cable and water spot detection in the application note.

 >> Water Detection: Sensing cable versus Flood sensor

 

HWg Video Flyer about water flood sensor

Recommended products

Poseidon2 3266

Cost-effective model for remote monitoring of sensors and detectors.

Ares 12 LTE

Industrial measuring and monitoring for 14 sensors with GSM and LTE communication and back-up power.

STE2 R2

WiFi and Ethernet, PoE available, temperature and humidity sensor with digital inputs. Up to 5 sensors of any RJ11 type.

Flood detector LD-12

A simple contact water leak detector.

Sensor WLD Relay 1W-UNI

A universal WLD (Water Leak Detection) sensor, with one WLD sensing cable input and 2 kind of outputs (1W-UNI sensor and relay output).

WLD sensing cable A

WLD sensing cable type A. Water is detected along the entire length of the WLD sensing cable.